Tomy Automatic microprocessor model ES 215 made inh Jaban
enables the set temperature and time for each mode program to be
stored in its memory.
MODE/PROCESS display enables real time monitoring of operation
ES-315 offers three mode programs.
Sterilization Mode It contains a delay start timer function that
allows operation to start 1 to 99 hours later.
Sterilization/warming Mode This mode is useful when not removing
culture media from the autoclave immediately after sterilization.
Sterilized media can be kept warm to prevent coagulation.
Heating Mode This mode program automates the dissolution of culture
media that can sometimes be a painful process when using a water
bath to boil them.
Chamber having a flat inner surface
All models are supplied with stainless steel wire mesh baskets. No
protrusions on inner surface of the chamber enable smooth loading
and unloading of the basket as well as block design of all pipe
fittings ensures safe operation.
Front access for easy maintenance
The exhaust bottle to capture and store exhaust steam is placed on
the front panel of the autoclave unit. Access to the chamber for
replacing water inside, as well as for routine maintenance and
inspection, is done on the front of the unit, which also permits
operators to replace bellows, saving costs for services by the
A microprocessor controlled monitoring system provides safe
Incomplete sterilization protection
In case of abnormal chamber temperature rise, the autoclave stops
its operation. In case of abnormal decrease in temperature, the
sterilization timer is temporarily suspended and then reactivated
when the set temperature is reached.
Chamber overpressure protection
If overpressure in the chamber is detected, the autoclave stops all
the function and indicates an error message simultaneously.
Chamber interior over temperature protection
If the temperature inside the chamber exceeds the set temperature
by 5°C or more, the autoclave stops all the function and indicates
an error message simultaneously to avoid overheating.
Inside the chamber overheat prevention, Outer wall of the chamber
overheat prevention, Overpressure prevention, Temperature sensor
disconnection prevention, Empty heating prevention, Leakage
breaker, Safety valve
Malfunction prevention devices
Low water level detection, Exhaust valve knob open/close detection,
Insufficient sterilization detection,
Chamber lid open/close detection
- Chamber capacity22 liters
- Built-in Steam exhaust bottle to Collect Steam pressure to
Prevent it to go out the instrument
-Operating temperatureup to 121C
-Operating pressure0 ~ 250 kpa
-Maximum operating pressure147 kpa
-Temperature ControlDigital, microprocessor controlled
- Temperature Increments1C
- Timer ControlDigital, microprocessor controlled
- Timer Display1 240 min ( Sterilization Cycle )
1 8hours ( Warming Cycle)
-Pressure gauge rangeAnalog,
-Sterilizing heat sourceStainless steel electric heater
-Working on 220v, 50hz.
Stainless steel basket with slatted bottom plate
Water level sensor 1, Inspection sheet 1,
Warranty card 1,
Customer card 1,
Operator's manual 1, Clear plastic accessory case 1, Attachment
screw for clear plastic accessory case 1
Stainless basket 1 (224 x 376mm)