|Main technical parameters：|
|1.Size of overall||5236*3550*1000mm|
|3.Upper and bottom beam||1000mm and 900mm|
|4.Size of hot platen：||1350*2700*42mm(q235)|
|8.Size of oil cylinders||3*320|
|14.Working pressure||380V 50HZ|
Installation and adjustment
1、After finished the installation for the Mechanical parts,
hydraulic system, electric control system, please clear away the
sundries on the hot press(especially for the surface of the hot
plates),electric cabinet, hydraulic system and so on and paint oil
to the guide holders(middle tray), holders and ladders(for hot
2.Turn on the power and observe whether the power indicator and the
voltmeter meet the requirements or not(360-410 v).Observe if the
touch screen is displaying well.
3、Open the temperature control switch to make sure it's good
running. Turn on the manual circulation pump switch, confirm it's
running well. Open the manual inlet oil switch, confirm the
electric 3-way thermostatic valve opening and closing with
4、Restore the original factory Settings on the touch screen and
load the hot pressing process parameters.
1.Check the Power indicator and Voltmeter.
2.Open the manual electric three-way thermostatic valve. After the
temperature reaches the set value, turn off the three-way
3.There is the trial operation of the machine at first time. Until
the trial operation is finished, the middle tray would be declined
to the bottom.
4.The glued board shall be sent to the lift platform by hydraulic
forklift and then put into the automatic feeding rack.
5.Press the feeding button which send the each layers to the hot
6.Press the start button. The oil cylinder rising which makes the
middle tray jacking. With the increasing of pressure , the each of
layers is pressed tightly, and then automatic pressure maintaining,
filling pressure, heating, cooling. After finishing maintaining
pressure, the system open the unloading valve pressure and the
middle tray falling automatically. The step of hot pressing is
7.After the each layers dropping is in place. Please press the
feeding button, and the finished boards will be pushed to the
discharging rack by the feeding rack. At the same time, the boards
in the feeding rack are also pushing to the each hot plates.
8.When the fan stops in the discharging rack, please remove the
cooling plate layer by layer and stack it neatly.
Previous: 15 Openings Film-faced Plywood Hot Press
Next: Laminate Film-Faced Hot Press Machine