Universal vehicle A/C Leak Testing Detector Tool / Flush Fitting
Adapter Kit
Tool Box contain:
2 x Clamp Assembly
2 x Support Plate (1/2" OD tube)
2 x Support Plate (5/8" OD tube)
2 x Support Plate (3/4" OD tube)
2 x Support Plate (7/8" OD tube)
2 x Support Plate (No slot)
Description:
These instructions are intended as guidelines for general operation
of the Universal Flush Fitting Kit. Follow the vehicle
manufacturer's instructions for flushing A/C systems.
The clamp assemblies and support plates included in this kit can be
installed on most A/C line or tube ends for attachment of the
flushing apparatus being used.
The support plates are slotted to allow for different size tubes or
line nuts to be supported against the lower end of the sealing
clamp. The chamfered area on the support plates allow the flared
end of the tubes to sit level. This way the sealing cone can be
seated without slipping or damaging the end of the tube.
Seating of the sealing cone into the fittings or tube ends does not
require the use of wrenches or other tools. Sealing cones damaged
by tools must be replaced.
Installation of the Sealing Cone:
1. After selecting the correct support plate to fit the tube or
line fitting, tighten the clamp screw until the cone is seated
tightly against the end of the tube or line fitting on the A/C
component.
2. While holding the clamp screw by hand, rotate the forcing nut an
additional 1/8 to 1/4 turn. This provides a leak-tight seal for the
flushing operation.
To remove the clamp assembly, hold the clamp screw and back off the
forcing nut to free up the sealing cone without damaging the end of
the cone.
When using adapters on a tube or fitting that is too small for the
sealing cone to enter, replace the coneshaped seal with the concave
seal.
To replace the sealing cone, hold the forcing nut and back out the
clamp screw until the cone is pulled out the end of the clamp
screw. Insert the desired sealing cone into the end of the clamp
screw, and tighten the screw until the cone bottoms in the screw,
using the non-slotted support plate against the end of the cone.
Notice : Do not use pliers or other tools to twist the sealing cone out of
the clamp screw, because it could damage the sealing cone
For mass order, we also can provide, then factory wholesale price will give you. Welcome your any trail order and inquiry ^ _ ^
For mass order, we also can provide, then factory wholesale price will give you. Welcome your any trail order and inquiry ^ _ ^
a. There are more types auto air conditioning products in our
company :
Compressor :