Portable Rebar Upsetter Forging Machine For Rebar Splicing
1. Product Description
Rebar Upsetting Forging Machine use the cold heading principle to make the steel
end for plastic deformation, diameter increased 16-32mm, and then processing thread.
1. High strength: the strength reach Grade I , stronger than the
and guarantees bar break under tensile stress
(tensile strength of connection point =1.1 times of connected bar).
It can satisfy the requirements stipulated in the Chinese standard
2. Wide working range: adaptable for 16mm-32mm rebar of different
3. High efficiency: upset forging and threading one joint only
needs no more than one minute, and handy operation and quick link.
4. Environmental protection and economy profit: no environment
pollution, can work all day, not affected by weather, economize
energy source and bar material.
After the mold is installed, reset the stroke limiting bracket.
Adjust the travel limit screw so that the stroke control in 15mm,
insert the test steel bar to the top of the mold center hole press
automation button. After the processing of the work-piece,
measurement it. If failed, then adjust stroke limit screw to make
the trip gradually increased, until processing of qualified
2- Safety operation rules
1. Workers have to be trained and tested OK then can work.
2. Before operation with rebar, first running the machine 2-3 mins
without processing, if it is running normally the process.
3. The feeding head of head should be plain and straight.
4. Before processing the rebar, the machine should be reset and
to ensure the same processing.
5. The processing rebar can not have the transverse cracks, when
the equipment break down should be eliminated timely.
6. Oil should be 68# hydraulic oil.
7. Workers should obey the safety rules
3- Machine Failure and Exclusion
|Trouble phenomenon||Reason||Method of exclusion|
|No action of cylinder||Motor reverse||Swap two-phase power supply|
|Electromagnetic spill valve failure||Replace the electromagnetic spill|
|Low oil level||Add hydraulic oil|
|Residual air in cylinder||Empty run 3-5min|
|The cylinder can only run in one direction or the oil cylinder
nonstop||Solenoid valve Cards||Find professional repair person|
|Die of steel||Die wear||Change mold|
|Small pressure||Professional Surge|
|Mold cracking||Too much pressure||Replacement of mold, professional regulator|
|Upsetting head is not full||Screw stroke wrong location||Adjustment|
3. Package & Delivery
Package: in wooden case
Delivery: 10-15 days after receiving the deposit.
4. Our Service
- Best price
- Quality assured
- Fast reply
- Satisfied after-sale service