1.Product Type:Built-in IC LED Pixel Strip -IC

2.type :WS2812B IC -Gray

3.level: 256 -View angle: 120° -

4.Input voltage: DC5V -

5.Color: full color 24-bit -

6.FPCB board color: Black/White -

7.LED strip width: IP30 IP65 :10mm -

8.LED strip width : IP67:12mm( include silicone sheathing)

9.Power:0.1W~0.3W/LED -

10.Standard Reel Length:5M/roll (16.4FT) -

11.Model: WS2812 strip 5050rgb chips -

12.Operating Temperature: -20 ~ +40°C -

13.Led Qty: 300LEDs/16.4ft 300 pixels/16.4ft -

14.Length x Widthx Height:IP30:5000mmx10mmx2mm IP65:5000mmx10mmx3mm IP67:5000mmx12mmx3.85mm -

Double Side Tape: IP30/IP65 . There is no double side tape on IP67. -Light up 1 color(red or green or blue) 0.1W/LED . Light up 2 colors (red+green) 0.2W/LED , Light up 3 colors (red+green+blue=mixed white) 0.3W/LED

Note:

Using 5VDC power supply. Higher than 5V will destroy it. If you need more data of WS2812 led strip, we will send it to you. The LEDs at the far end of the strip might be dimmer because of the added resistance and voltage drop that occurs during the current flows to that end of the strip. The solution is adding DC5V voltage every 16.4ft or 32ft according to the actual situation .

Waterproof Level:

-IP30: Non-waterproof . Only work indoor .

-IP65: Silicone Coating Splash Proof .Dust prevention splash proofing designs. Only work indoor.

-IP67: Sheating Waterproof. Dust prevention water proofing designs. Can work outdoor but the 3 PIN connectors are non-waterproof. -IP68:Glue-Pouring Waterproof.Dust prevention water proofing designs. Can work underwater.3 PIN waterproof connector.

IP68 needs to be customized.

Package List:

1*5M WS2812 LED Flexible Pixel Strip

1*3 pin male connector

Power adapter or controller is not include

1. Why the end of LED strip looks like red or yellow when you light up maximum brightness White Light ?

A1: It is better to add DC5V voltage every 5M(16.4FT), because the LEDs at the far end of the strip might be dimmer due to the added resistance and voltage drop that occurs as the current flows to that end of the strip.

2. Why do I light up a few LEDs ?

A2: Please make sure you using the right power supply . For this LED strip , it is DC5V .Please don't use DC12V power supply for it . It will burn this LED strip .

3:The controller is defective . Please make sure the controller can work fine

A3. What are the functions of the two extra wires on two ends ,one is white ,one is red ?

4: They are using to connected the DC5V power supply when the LED strip out of voltage . So we also call them voltage adding wires .

4. Can I connect them in series when I want to control 4 reels of them ? A4: Yes , they can end to end connect many reels .