CNC processing type: rust removal, sand blasting, carbonitriding, bushing, turning, milling
Materials: aluminum, stainless steel, bronze, brass, copper, precious metals, steel alloys, precious metals
Micro machining or not: micro machining
Method: CNC milling parts/CNC turning parts
Surface treatment: polishing, etching, vibration grinding, laser engraving
Tolerance:+0.001 mm
Weight: 0.1~2.0 kg '
Surface treatment: powder coating, nickel plating, zinc plating, chromium plating
Color: OEM
Size: OEM
Our service: OEM and ODM CNC processing according to customer requirements
Equipment: CNC machining center, CNC lathe, CNC turning, milling
Product category: display accessories
Equipment: 3/4/5 axis machine tool, CNC lathe, CNC turning, CNC milling
Certificate: ISO 9001:2015 and IATF 16949

What causes the failure of turning milling composite processing
At the initial stage of use, the turning milling compound processing lathe has been installed and commissioned for about a year. The fault at this stage is characterized by high fault frequency and rapid reduction with the increase of service time. The causes of frequent failures at the initial stage of use are roughly as follows:
1. Electrical causes.
A large number of electronic components are used in the control system of turning milling compound lathe. Although these components have undergone long-term aging test and other screening in the manufacturer, some components with poor performance cannot withstand the test in actual use due to circuit heating and the influence of variable load, surge current and back EMF on the switch. The whole system cannot work normally due to current impact or voltage breakdown, or change of characteristic curve.
2. Hydraulic cause.
After a long period of transportation and installation after the turning milling composite processing leaves the factory, some parts of the hydraulic system are free of oil for a long time, the lubricating oil in the oil cylinder is dry, and the oil mist lubrication cannot take effect immediately, resulting in rust on the hydraulic cylinder or oil cylinder. In addition, if the newly installed air pipe is not cleaned, some impurities and moisture may also enter the system, causing the initial failure of hydraulic and pneumatic components.
3. Mechanical causes.
Although the turning milling compound lathe has run in before leaving the factory, the time is short, mainly due to the running in of the spindle and guide rail. Because there are micro and macro geometric errors in the machining surface of the part, the machining surface of the part is relatively rough before the complete running in, and there may be errors in the assembly of the part. Therefore, large wear will lead to a large gap between the relative moving parts of the equipment, resulting in failure.

Specification:

FAQ:
1. How big is your facility?
Our factory covers an area of 3000-5000 square meters, with more than 30 experienced employees, located in Shenzhen, China.
2. How soon can I get the samples?
Depending on your specific project, it usually takes 10 to 20 days.
3. How to enjoy OEM services?
Usually, according to your design drawings or original samples, we will provide you with some technical solutions and quotations. After you agree, we will do it for you.
4. When I send you drawings, what should I specify?
Please tell us at least the raw materials, finishes and quantities.
Jane, can you make a design for me?
We do not provide design services. You are responsible for submitting 2D and 3D CAD drawings, and then we can provide manufacturing design review after receiving your order

 We are CNC Machining manufacturer, customized high precision parts, Tolerance: +/-0.01 mm, Special area: +/-0.002 mm.

Certificate

 ISO9001:2015,AS9100D,ISO13485:2016,ISO45001:2018,IATF16949:2016,ISO14001:2015,ROSH,CE etc.

We can produce mechanical parts, automobile parts, electronic parts, aerospace parts, medical device parts, communication equipment parts, new energy parts, construction and household products parts.

Cooperative Partner