Engine Assembly and Engine Parts for More models as following:

Office:

More Spare Parts:

Packing:


Wearhouse:

Tips:

Under normal circumstances, the rear axle part of the car produces an abnormal sound, which is not unrelated to the clearance adjustment of the pot corner gear. In terms of assembly processes, the following are as follows:
1. Preload of active bevel gear bearings. Select an adjustment gasket of the appropriate thickness, install it between the inner housing ring and the spacer sleeve of the bearing in the active bevel gear, and tighten the lock nut according to the specified torque. To determine the rotational moment of the active bevel gear, the bearing should be coated with grease, but not oil sealed, and the active gear should be rotated on both sides (not less than 5 turns in each direction). Pay attention to observe whether the cage of the bearing is deformed, whether the roller is in place, and if the measured rotational torque does not meet the requirements, the adjustment gasket should be replaced and readjusted.
2. Preload of driven bevel gear bearings. After the preload adjustment of the active bevel gear bearing is completed, rotate the left and right adjustment rings to adjust the preload of the driven bevel gear bearing so that the rotational torque measured on the active bevel gear protrusion meets the specified requirements.
3. Active bevel gear rear bearing assembly. The active bevel gear can be easily fitted by cleaning the bearings during assembly, applying butter, sticking the rollers firmly, opening the rear cover of the rear axle housing for observation, or removing the front bearing connection of the active bevel gear. Then, in turn, other parts are inserted and tightened to avoid damage to the bearing. When testing, it is necessary to decompose the rear axle, which should be adjusted according to the specifiions, and if necessary, the main reducer should be decomposed for maintenance.
4. Detect bearing wear. The wear of a ball (column) bearing can be judged by measuring its radial and axial clearance.
Generally speaking, the gap is still relatively easy to adjust, mainly the bite marks. After replacing the pot angle gear, first put the pot tooth or large wheel on the differential shell, and then fix the bearing seat and flower nut on both sides, basically preset a position, install the small wheel (angle teeth), the small wheel tooth surface is coated with colorant, generally red dan powder, by hand, to see the tooth surface to eat the color, adjusted to the large wheel working tooth surface Of the mark is small, but can not out of the tooth end.
The adjustment position is the adjustment of the flower nut at both ends of the large wheel, and the other is the adjustment of the thickness of the gasket behind the small wheel. As for the gap you said, you can squeeze the lead wire on the tooth side, and then measure the thickness of the lead wire after squeezing. The specific side gap requirements depend on the module number and working conditions of the gear to judge, but the conventional 0.3 ~ 0.4mm is no problem.

Shenzhen Tai Trade Ltd, Specialized in Distributing Japanese Engine Assembly and Engine Spare Parts Since 2012. We have a large range of these Engine And Spare Parts Perfect Condition and High Quality, we can provide New and Used Engines, Spare Parts for ISUZU, MITSUBISHI, NISSAN, HINO, TOTOTA, KOMATSU, , KIA, HYUNDAI and so on.

Shenzhen Tai Trade Ltd, was established in 2002 as a special Flywheel and Ring Gear manufacturer named TWOO Auto Parts Power Factory. In 2010 we renamed to Twoo Auto Parts Co., Ltd and began to export by ourselves to all over the world. In order to expand our product line and supply more and complete service to customer, we set up our own trade company--- Twoo Auto Parts Co., Ltd in 2011.

Now we supply the Starter Motor, Alternator, Compressor, Flywheel, Clutch Parts, Crankshaft, Camshaft, Turbocharger, Brake Disc and so on. Our sales network begun from Europe and North America and now has spread to South Africa, South America, Australia, Middle East and other countries and regions.