Huawei S5720-56C-HI-AC S5700 48 Ports 10GE SFP+ Ethernet Network Switch

Four 10GE SFP+ ports

Applicable modules and cables:

· GE optical module

· GE-CWDM optical module

· GE-DWDM optical module

· GE copper module

· 10GE SFP+ optical module (OSXD22N00 not supported)

· 10GE-CWDM optical module

· 10GE-DWDM optical module (applicable in V200R009C00 and later versions)

· 1 m, 3 m, and 10 m SFP+ high-speed copper cables

· 5 m SFP+ high-speed copper cable (applicable in V200R009C00 and later versions)

· 3 m and 10 m AOC cables

· 0.5 m and 1.5 m SFP+ dedicated stack copper cables (used for zero-configuration stacking, supported in V200R011C10 and later versions)

Ground screw

NOTE:

It is used with a ground cable.

ESN label

NOTE:

You can draw it out to view the ESN and MAC address of the switch.

Rear card slot 1

NOTE:

This slot is reserved for future use.

Rear card slot 2

NOTE:

Card supported: ES5D21X04S01 (4-Port 10 GE SFP+ Rear Interface Card)

Power module slot 2

NOTE:

Applicable power modules:

· 350 W DC power module

· 600 W AC power module

Power module slot 1

NOTE:

Applicable power modules:

· 350 W DC power module

· 600 W AC power module

· Using AC power modules: ±6 kV in differential mode, ±6 kV in common mode

· Using DC power modules: ±1 kV in differential mode, ±2 kV in common mode

Four fixed 10GE SFP+ ports on the front panel or ports on the 4-port 10GE SFP+ rear interface card

NOTE:

The switch supports service port stacking since V200R009C00.

100 V AC to 240 V AC, 50/60 Hz

-48 V DC to -60 V DC

90 V AC to 264 V AC, 47 Hz to 63 Hz

-38.4 V DC to -72 V DC

Typical power consumption (30% of traffic load)

· Tested according to ATIS standard

· EEE enabled

· No PoE power consumption