Paper strapping Box Binding Machine , Manual New Condition Vertical Baler

Manual New Condition Vertical Baler Paper strapping Box Binding Machine

Four-door garment hydraulic baler can compress and pack all kinds of waste paper, waste plastic, waste fabric, garment, quilt, pillowcase, pillow, straw, cotton, straw, grain, etc. Packaging is to improve labor efficiency and reduce labor intensity.

Operation method and matters

1. Check whether the appearance of the equipment is abnormal and whether there are any safety hazards around it (long rods or other foreign objects are prohibited from being placed near the machine). After confirming the normal, open the electric control box load switch, the key switch is turned to the open position, and the emergency stop button is opened, and the electric control box power indicator lights up.

2. Put a large piece of paper on the bottom of the machine, close the upper and lower iron doors, and rotate the lower door fastener to lock it tightly. (The lock must be tightly locked when the door is locked to the end, because the internal pressure is large when the machine is working, and the lock is not tight. A gap in the door will cause the safety sensor to act and the machine will stop working.)

3. Press the row button to press the pressure head down to the bottom and automatically rise to the upper position to stop. The air pressure once resets the outsourcing chain on the pressure head.

4. Open the upper iron door and put the material into the machine evenly until it is full, and close the upper iron door (must be closed in place, otherwise the safety photoelectric detection sensor on the door will act, the machine will not start).

5. Press the row button, the pressure head goes down, and when it is pressed to the bottom position, it will automatically rise back to the upper part to stop.

6. Repeat operation 4-5 until the siren sounds on the electric control box. The warning has reached the set packing height. At this time, the indenter presses the paper bag and stops. If you do not need to set the packing height, you need to bundle the bag in advance. Down button for 2 seconds, at this time the machine starts, the pressure head presses the paper bag and stops, and continues to the next step).

7. Open the upper and lower doors and put a wire or plastic rope from the back of the machine through the corresponding threading groove of the indenter and the bottom to expose the machine from the front, and tie the exposed two ends at the front of the machine (because The expansion of the bag, the line should not be too tight, leaving a certain margin to prevent disconnection), wear all the lines and tie them as described above.

8. Place a tray in front of the machine. Take out the outsourcing chain at the back of the machine and put it in the out of the card slot on the indenter.

9. Check if there is any person or foreign object in the package position and confirm the safety.

10. Press and hold the up button, the head rises to drive the bag out and turn it onto the tray, and transport the bag to the designated position. (If the dangerous button is released in the process of bag out, the machine will immediately release the bag. , continue to operate after the danger is removed), a work cycle ends.

Single cylinder

Hebei Jinguang Packing Machine Co.Limited is a professional corrugated carton printing equipment and related machinery for carton production over ten years.Our company is located in the Lisiwei industrial part ,Dongguang country Hebei Province.Our main products are corrugated carton box printing,slotting,die cutting machine (simiauto,automatic).Middle high speed corrugated paperboard production line,automatic folder gluer machine,stitching machine,flute laminator ,thin blade slitter,partition machine ,automatic assemble machine,binding machine and so on.