| 1. Scope |
| 1.1 | Specification covers production and inspection of Connector. | This specification content is applicable to the production and
inspection of our company's ordinary series bar-type connector (pin
header) products. |
| 2. Use Condition |
| 2.1 | Ambient temperature Range | -25+85 |
| 2.2 | Applicable Wire Sizes | AWG#22#28 |
| 2.3 | Applicable PC board thickness | 1.2~1.6 mm |
| 3. Appearance and Dimension |
| 3.1 | Appearance | Product surface without defect, dirt, crack, and mechanical damage.
Contact without rust, plating not oxidized and not peeled. |
| 3.2 | Dimension | According to drawings |
| 3.3 | Exchangable | Exchangable with same specification products. |
| 4. Material |
| (See separate table above for detailed material breakdown) |
| 5. Electrical Performance |
| 5.1 | Rated Voltage | 250V AC/DC |
| 5.2 | Rated Current | 2A AC/DC |
| 5.3 | Contact Resistance | 10 m |
| 5.4 | Insulation Resistance | 1000M |
| 5.5 | Dielectric Strength | 800V AC/minute |
| 6. Mechanical Performance |
| 6.1 | Male contact Retention force | 10N per pin |
| 6.2 | Female contact Retention force | 10N per pin |
| 6.3 | Plug-in force | 3N per pin |
| 6.4 | Plug-out force | 0.5N per pin |
| 7. Endurance Characteristics |
| 7.1 | Soldering rest | Time: 2.50.5S, Temperature: 2305, Area of Soldering: 95% |
| 7.2 | Resistance to soldering Heat | Time: 51S, Temperature: 2305, Appearance: No Damage |
| 7.3 | Heat test | Time: 96h, Temperature: +853, Appearance: No Damage, Contact
resistance: 20 m |
| 7.4 | Cold test | Time: 48h, Temperature: -253, Appearance: No Damage, Contact
resistance: 20 m |
| 7.5 | Temperature Cycling | Low temperature: -253, High temperature: 853, For 5 cycles.
Appearance: No Damage, Contact resistance: 20 m |
| 7.6 | lnvariab lenes humidity | Temperature: 602, Relative humidity: 90%-96% RH, Time: 96h,
Appearance: No Damage, Contact resistance: 20 m, Insulation
Resistance: 100M |
| 7.7 | Salt Spray | Salt concentration: 51%, Temperature: 352, Time: 162h, Appearance:
No Damage, Contact resistance: 20 m |
| 8. Packaging, Transportation, Storage |
| 8.1 | Packaging | Plastic bag for inner packing of plastic parts; Panel mounting
material packing for inner terminal, marked with product name,
specification model, quantity, production date. Exterior package is
carton, marked with packing list including product name,
specification model, quantity, dispatch date. Product in box must
not rock. |
| 8.2 | Transportation | Allow for any way transportation, cannot get wet and mechanical
injury. |
| 8.3 | Storage | Ambient temperature between -10 to +40, Relative humidity 80%.
Store in a warehouse without acidic, alkaline air, and other
corrosive gases. |
