IEC 62196 Vehicle Testing Equipment 5000N Drive Over Test For Plug / EV Connector
|
IEC 62196 Vehicle Testing Equipment 5000N Drive Over Test For Plug / EV Connector Product information: The test equipment is used to check whether a plug or vehicle connector shall have adequate resistance to damage from being driven over by a vehicle, unless it is provided with a cable management system which prevents the accessory from being left on the ground. It is required by IEC 62196-1:2022 clause 33, IEC 62752:2016 clause 9.34, etc. Test...
Sinuo Testing Equipment Co. , Limited
|
Apparatus For Testing Resistance To Abnormal Heat Of Insulating Sleeves Of Plug Pins , IEC 60884-1 Test Equipment
|
... sleeves of plug pins , IEC 60884-1 test equipment 1. Product information: To determine testing resistance to abnormal heat of insulating sleeves of plug pins, in according to IEC 60884-1 figure 40,This test apparatus consists of an insulating plate A...
KingPo Technology Development Limited
|
IEC 61851 EVSE Testing Equipment Connector Plug Cable Strain Relief Test
|
IEC 61851 EVSE Connector Plug Cable Strain Relief Testing Equipment Complied Standards & Clauses IEC 61851-1 2017 Electric vehicle conductive charging system - Part 1: General requirements clause 11.6. IEC 62196-1 Ed.4CDV 2020 clause 25.3 Figure 17 and table 11. IEC60309-1: 2012 clause 23.3, etc. Equipment Overview This cable strain relief test equipment is used to test the vehicle plugs......
Sinuo Testing Equipment Co. , Limited
|
IEC 61558 1 IEC 60950 Mandrel Test Equipment For Insulation Material
|
IEC 61558 1 IEC 60950 Mandrel Test Equipment For Insulation Material IEC 61558-1 Mandrel Test Equipment For Insulation Material Mandrel Test Device Description: This device is used to test the Insulation anti damage strength verification for non separable thin layer materials. Confirm to IEC60950 Safety of information technology equipment, IEC60065-1 Audio, video and similar electronic apparatus-Safety requirements, IEC 61558-1. Test......
Dongguan Kingpo Technology Limited
|
IEC 60669-1 Test Equipment Self Ballasted Lamp Bulb Load Box Three Test Stations
|
... – Part 1: General requirements clause 19.3 Test for switches intended for self ballasted lamp loads. Application of Self Ballasted Lamp Load Box: Switches intended for self ......
HJ AUTOMATIC CONTROL TECHNOLOGY CO., LTD
|
IEC 62133 Battery Testing Equipment Electric Vibration Testing System
|
..., fire or explosion. The electrodynamic vibration test system is a precision test equipment that simulates the actual working environment of a battery. The vibration test system consists of four parts: vibration test bench, power amplifier, controller and...
Guangzhou HongCe Equipment Co., Ltd.
|
UL 817 Electrical Wire Testing Equipment , Abrupt Pull Plug Testing Equipment 6 Groups
|
... strength of the conductor wire. The plug blade is fixed in the socket, and the tail end of the wire is connected to the hammer bar to test the pull. After that, weights were hoisted to perform swing tests and current tests. Comply with the standards: In...
DONGGUAN DAXIAN INSTRUMENT EQUIPMENT CO.,LTD
|
Fire Resistance Test Furnace IEC 60331 , Impact Test Equipment For Wire / Cable
|
IEC 60331 Wire and Cable Fire-resistance Impact Testing Equipment Descriptions: Wire and Cable Fire-resistance Impact Tester is used to detect the fire resistance of cable wiring or power grid, burning in not less than 830 degrees, the flame, and exerts certain impact vibration, cable integrity test circuit. Standards: IEC 60331 Testing of wire and cable - circuit integrity under flame conditions IEC......
DONGGUAN YUYANG INSTRUMENT CO., LTD
|
IEC 60331 Burning Testing Equipment For Electric / Optical Fibre Cables Circuit Integrity
|
... whether keep circuit integrity under fire conditions. Standards: GB/T19216 Test for electric or optical fibre cables under fire conditions---Circuit Integrity--Procedures and requirement for fire with shock--Cables of rated voltage up to and ......
Dongguan Hust Tony Instruments Co.,Ltd.
|
Chamber Type Iec 60529 Ip Testing Equipment Waterproof
|
Chamber-Type IEC60529 waterproof IP Testing Equipment for IPX1/2, IPX3/4 and IPX5/6 Testing 1. Function of the Comprehensive Test Chamber The chamber equipment integated with drip box for IPX1 and IPX2 testing, R600 oscillating tube for IPX3 and IPX4 ......
Pego Electronics (Yi Chun) Company Limited
|
Submit your “iec compliant plug test equipment” inquiry in a minute :