clause 3 3 cable testing equipment

Brand Name:HongCe

Model Number:HDX1315

Place of Origin:China

IEC 60227-2 Clause 3.3 Cable Testing Equipment Snatch Tester With A 0.5kg Weight IEC60227-2 clause 3.3 Snatch test The requirements are given in 5.6.3.3 of IEC 60227-1. A sample of cord of appropriate length shall be attached by one end to a rigid support...

Brand Name:Sinuo

Model Number:SN1112E

Place of Origin:China

... is used to test the bending performance of copper core or copper alloy sheathed mineral insulated general wiring cables to verify their reliability. It uses the motor to drive the turntable to rotate the cables. For 500V cables, a voltage of 750V and for

Brand Name:Kingpo

Place of Origin:China

....2 clause 22.7. It is used for checking mechanical strength of completed flexible cables. This cable tester consists of a carrier C (see IEC60245-2 Figure 1),a driving system for the carrier and four pulleys for each sample of cable to be tested. The

Brand Name:Sinuo

Model Number:SNQC1010

Place of Origin:China

... equipment is used to check whether a plug or vehicle connector shall have adequate resistance to damage from being driven over by a vehicle, unless it is provided with a cable management system which prevents the accessory from being left on the ground.

Brand Name:SHC

Model Number:SC-FTTC

Place of Origin:China

IEC60245-1 Figure 1 Flexing Test For Flexible Cable Speed 0.33M/S Standard: IEC60245-1 Rubber insulated cables-Rated voltages up to and including 450/750 V-Part 1: General requirements clause 5.6.3.1, IEC60245-2 Rubber insulated cables-Rated voltages up ...

Brand Name:SKYLINE

Model Number:SL-FL38

Place of Origin:China

Cable H / V Stainless Steel Flammability Testing Equipment Standards According to the clause 1060 (vertical burning and FT1 test), 1061(cables burning test), 1080(VW-1 burning test), 1090(electric cable specimen horizontal burning test, optional item), 1100 (horizontal specimen/ FT2 burning test)of UL1581-2008, 6.8 (standard arcing test), clause 9.1～9.5 of UL2556-2007, clause 4.26 of JIS C3005-2000 Application Apply to check the single cable

Brand Name:PEGO

Model Number:PG-BDT

Place of Origin:China

... Test Equipment for Adjusting Luminaire Conforms to IEC60598-1 Clause 4.14.3 1. Introduction The bending test equipment for adjusting luminaire is designed to meet the test requirement of IEC60598-1 clause 4.14.3. The flexible cord or cable of adjusting...

Brand Name:HJ

Model Number:HDX1302

Place of Origin:China

...clause 5.6.3.1; IEC 60245-2 ‘Rubber insulated cables - Rated voltages up to and including 450/750 V - Part 2: Test methods’ clause 3.1 and figure 1; IEC 60227-1 ‘Polyvinyl chloride insulated cables of rated voltages up to and including 450/750 V –

Brand Name:KingPo

Place of Origin:China

...-1 clause 4.14.3. The adjustment device, equipped with the appropriate cable or cord shall be operated in accordance with following table. A cycle of operation is a movement from one extreme of the range to the other and back to the starting position.

Place of Origin:China

Brand Name:KeRang

... for general application-Test at low temperature. Application:It is used to test at low temperature for insulating and sheathing materials of electric cables. Test sample:Rubber, insulating and sheathing materials of electric cables. Parameters: Item name

Brand Name:DAXIAN

Model Number:DX8309

Place of Origin:China

... type and non-threaded terminal fixed connection components to test whether they can withstand the mechanical stress that occurs during normal use. Conform to the standard: GB2099.1-96, GB16915.1-97 and IEC884-1 in the corresponding clauses and other